Generated.

[homepage.git] / blog / index.html

diff --git a/blog/index.html b/blog/index.html
index 2028bfd7c83c5e45f508c3ffa472215d5e3f7c1f..e1868facf1fe93e2e948796721c760c5f9dbb02b 100644 (file)
--- a/blog/index.html
+++ b/blog/index.html
@@ -95,7 +95,7 @@ packets across mesh networks, and OLSR, B.A.T.M.A.N. and
 B.A.T.M.A.N. advanced are protocols used by several free software
 based community mesh networks.</p>
 
-</p>The batman-adv protocol is a bit special, as it provide layer 2
+<p>The batman-adv protocol is a bit special, as it provide layer 2
 (as in ethernet ) routing, allowing ipv4 and ipv6 to work on the same
 network.  One way to think about it is that it provide a mesh based
 vlan you can bridge to or handle like any other vlan connected to your
@@ -105,13 +105,13 @@ least since Debian Wheezy, and it is fairly easy to set up.  A
 introduction</a> is available from the Open Mesh project.  These are
 the key settings needed to join the Oslo meshfx network:</p>
 
-<table>
+<p><table>
 <tr><th>Setting</th><th>Value</th></tr>
 <tr><td>Protocol / kernel module</td><td>batman-adv</td></tr>
 <tr><td>ESSID</td><td>meshfx@hackeriet</td></tr>
 <td>Channel / Frequency</td><td>11 / 2462</td></tr>
 <td>Cell ID</td><td>02:BA:00:00:00:01</td>
-</table>
+</table></p>
 
 <p>The reason for setting ad-hoc wifi Cell ID is to work around bugs
 in firmware used in wifi card and wifi drivers.  (See a nice post from